Cold Starting; Warm Starting - Echo I - START Instrucciones De Instalación Y Operación

- S
:
STARTING

COLD STARTING

PB-230LN/231LN
1a. Move stop switch button (A) away from stop position.
Move throttle position lever (B) forward to idle position.
PB-260L/261L
1b. Move throttle lever (A) to IDLE DETENT position.
2. Move choke lever (C) to cold start (closed) position.
3. Pump primer bulb (D) until fuel is visible and flows freely in
the clear fuel tank return line. Pump bulb an additional 4 or
5 times.
NOTE:
Energy is stored in the starter spring each time the handle/
rope is pulled. Generally two to six pulls, using light pulling
forces, will store enough energy to engage the starter and
spin the engine. Do not pull the rope out to end stop.
4. Set the unit on a flat, clear area. Gently pull starter handle/
rope (E) until engine fires or 2 to 3 engine engagements.
5. After engine fires or 2 to 3 engine engagements, move
choke lever (C) to "run" (open) position.
6. Pull starter handle/rope (E) until engines starts and runs.
7. Allow engine to warm up at idle for several minutes.
NOTE:
If engine does not start with choke in "run" (open) position
after 5 engine engagements, repeat instructions.
8. After engine warm up, gradually increase engine RPM.

WARM STARTING

The starting procedure is the same as Cold Start except DO NOT
close the choke.
1. Move stop switch button (A) away from the STOP position.
2. Set the unit on a flat, clear area and gently pull the recoil
starter handle (E) until engine fires.
NOTE:
If engine does not start after 5 engine engagements, use Cold Start Procedure.
I
TART NSTALLATION
/O I
PERATING NSTRUCTIONS
B
PB-260L/261L
A
PB-230LN/231LN
A
C
D
PB-260L/261L
E
3