Uline H-7906 Guia De Inicio Rapido página 2

3. Connect the end of long brace to front leg using
3/8-16 x 1/" hex head cap screw and hex nut.
(See Figure 2)
Figure 2
4. Pivot the rear panel upward and pivot the long
bottom brace upward. Connect the other end of
long bottom brace to rear panel lug using the
3/8-16 x 1/" hex head cap screw. Do not attach
hex nut. (See Figure 3)
Figure 3
5. Connect the short brace to middle panel lug using
3/8-16 x 1/" hex head cap screw and hex nut.
(See Figure 4)
Figure 4
PAGE 2 OF 9
ASSEMBLY INSTRUCTIONS CONTINUED
6. Pivot short brace up and connect to rear panel lug
over the long bottom brace, using the same hex
head cap screw. The short brace will be installed
over the long brace. Place hex nut onto hex head
cap screw where the braces connect to the rear
panel lug. Do not fully tighten. (See Figure 5)
Figure 5
7. Repeat steps three through eight for the remaining
long bottom and short middle braces on opposite
side. (See Figure 6)
Figure 6
DANGER! Do not use step stand unless all
components and the cap screws are in place
and nuts are securely tightened.
0521 IH-7906