Filling With Petrol; Setting The Cutting Height; Adjust Front Wheels; Connect The Connecting Cable - Grizzly BRM 46-140 BSA Q-360 InStart Traducción Del Manual De Instrucciones Original

Filling with Petrol

Warning! Petrol is flammable
and hazardous to health:
- Keep petrol in containers intended for
this purpose;
- Only refuel outdoors and never with
the engine running or when the ma-
chine is hot;
- Open the filler cap carefully to allow
excess pressure to escape;
- Do not smoke whilst refuelling;
- Avoid skin contact and inhalation of
the fumes;
- Remove spilt petrol;
- Keep petrol away from sparks, open
flames and other ignition sources;
- Do not use petrol/oil mixtures;
- Use normal or super unleaded
petrol;
- Only use clean, fresh petrol;
- Do not store petrol for longer
than one month, as its quality
deteriorates
1. Unscrew the filler cap (
in the petrol to the lower edge of the
filler.
Do not fill the tank entirely, to allow
the petrol room to expand.
2. Wipe away petrol residues around the
filler cap and close the filler cap.

Setting the Cutting Height

The equipment has 6 positions for setting
the cutting heigh (25-75 mm):
1. Pull the lever (20) outwards and
push it to the desired position .
2. Push the lever back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.

Adjust front wheels

The lawn mower is extremely flexible and
manoeuvrable thanks to the special con-
struction of the front wheels.
These are to be adjusted according to the
specific situation as follows:
9) and pour

Connect the connecting cable

Before you can start the machine, you
must establish the connections between
the start button, battery and electric motor.
Select a greater cutting height for
the first cut of the season.
1. The alignment of the wheel is
fixed once the clamping brack-
ets (14a) snaps into place. If
the wheel is desired in another
running direction, lift clamping
bracket to release it. Bring wheel
into new position and clamping
brackets snaps into place once
again.
2. Should the front wheels remain
able to move freely, lift the clamp-
ing brackets (14a) and do not
place them in the opening, but
rather set them on the plate be-
side it.
1. Connect the black connector of
the E-Start (40).
2. Connect the white connector of
the battery (41).
GB
103