Sanus XF228 Manual De Instrucciones página 8

Ocultar thumbs Ver también para XF228:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
2
Mount the Wall Plate
2-1
Locate studs
41 - 61 cm
(16 - 24 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[24]
[23]
8
Wood stud
< 16 mm
(5/8 in.)
[01]
[01]
For assistance in determining wall plate location, see Height
Finder at sanus.com.
Verify the center of the stud(s) using an awl, a thin nail, or an
edge to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8
in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.).
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 89 mm (3 1⁄2 in.), using
a 5.5 mm (7/32 in.) diameter drill bit.
89 mm
(3 1/2 in.)
CAUTION:
Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [23].
Tighten the lag bolts [23] only until the washers [24] are
pulled fi rmly against the wall plate [01].
13 mm
5.5mm
(1/2 in.)
(7/32 in.)
6901-002115 <05>
Tabla de contenido
loading

Tabla de contenido