Tabla de contenido
Section 1 Safety
Never operate the bath with the immersion circulator removed.
Do not mount the immersion circulator backwards; the line cord could
contact the reservoir fluid. Ensure the electrical cords do not contact
any of the plumbing connections or tubing.
Never place the circulator in a location or atmosphere where excessive
heat, moisture, or corrosive materials are present.
Ensure the tubing you select meets your maximum temperature and
pressure requirements.
Ensure all communication and electrical connections are made prior to
starting the circulator.
Never operate the circulator without fluid in the reservoir.
Oil-based fluids expand when heated. Fill the reservoir only to the
minimum level.
Use only the approved fluids listed in this manual. Using other fluids
voids the warranty.
Other than water, before using any approved fluid, or when performing
maintenance where fluid contact is likely, refer to the manufacturer's
SDS and EC Safety Data Sheet for handling precautions.
When using ethylene glycol and water, check the fluid concentration
and pH on a regular basis. Changes in concentration and pH can
impact system performance.
Do not clean the circulator with solvents, use a soft cloth and water.
Drain the reservoir before it is transported, and/or stored.
Always turn the circulator off and disconnect the supply voltage from
its power source before moving or before performing any service or
maintenance procedures.
Transport the circulator with care. Sudden jolts or drops can damage its
components.
Refer service and repairs to a qualified technician.
1-9
Thermo Scientific
Tabla de contenido
