Midland Alan 42 DS Manual De Instrucciones página 10

is turned on, it always transmits with high power (4W). By pressing this button,
the unit will transmit with low power (1W). The display will show "LOW". Press
again the H/L button to return to "HIGH" power level.
12. LOCK button: it allows you to lock the keyboard, thus avoiding accidental use
of the keys.
13. Q.UP - Q.DOWN buttons: to skip 10 channels up (Q.UP) or 10 channels
down (Q.DOWN).
14. Loudspeaker
15. Dual Watch: this function allows the synthonization on two different channels
at the same time. Thanks to this function, you can monitor a second channel.
When a signal on the second channel is received, the conversation on the first
channel is automatically interrupted and the receiver switches on the second
channel. The monitoring starts again 4 seconds after the signal end.
To activate this function, operate as follows:
- Select the desired channel through the channel selector
- Press the DW button
- Select the second channel
- Press the button DW again
- To cancel the function press again the DW button or the PTT button.
16. SCAN /Noise Blanker button: with this control, you can automatically seek for
a busy channel.
- Rotate the squelch clockwise until the background noise is no longer he-
ard; or rotate the knob totally anti-clockwise to use the digital squelch.-
Press the ''SCAN'' button: the transceiver will scan automatically all the
channels until a carrier is being received.
- When it finds the carrier, it stops and starts again some seconds after the
end of the communication on the channel.
- When the radio is transmitting, the scan function is deactivated.
- Keep pressed the SCAN button for 2 seconds to activate the Noise Blan-
ker filter; "AM" or "FM" will blink on the display.
17. button: display lighting (temporized).This function allows to operate
in darkness conditions. By pressing this button, the display is lighted for 5
seconds.
18. Push to talk button (PTT): Its pressure activates the transmission. When it is
released, the receiver is activated.
19. Battery compartment: insert 6 alkaline batteries or 8 rechargeable
Ni-Mh batteries.
20. Hole for wrist belt
21. Channel UP: to skip to the next channel. Keeping this button pressed, the
"autorepeat" function is obtained.
22. Channel DOWN: to skip to the previous channel. Keeping this button pressed,
4 | Alan 42 DS instruction guide
the "autorepeat" function is obtained.
23. Battery pack contact: lift the button and take the batteries out (see drawing).
24. Auxiliary antenna contact: for the connection to the vehicular adaptor.
19
S
2 D
N 4
A L A
24
Installing/removing the battery case
Alan 42 DS works with both Alkaline and with Ni-Mh rechargeable batteries.
For this reason, 2 kinds of battery case are supplied: empty battery case for 8
penlight AA type rechargeable batteries with charge jack and an empty battery case
for 6 penlight AA type alkaline batteries.
To remove the battery case, lift the side trigger and slide the battery case off. Put
the batteries in.
To replace the battery case, slide it again onto the dual track system of the back side
of the transceiver.
Alan 42 DS instruction guide | 5