Description; Purpose; Overview; Safety - Powerworks HMM401 Manual Del Usuario

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is intended for hammer drilling in concrete,
bricks and masonry, as well as for light chiselling work. It is
also suitable for drilling without impact in wood, metal,
ceramics and plastic, as well as for screwdriving.
1.2

OVERVIEW

Figure 1.
1 Auxiliary handle
2 Depth stop rod
3 SDS chuck
4 Rod adjustment button
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

INSTALL THE BATTERY PACK

Figure 2.
5 Mode selection switch
6 Reversing button
7 Switch trigger
8 LED work light
WARNING
WARNING
WARNING
English
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3

REMOVE THE BATTERY PACK

Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4

INSTALL THE BIT

Figure 3.
1. Put the direction button in the center position to lock the
switch triiger.
2. Move the coupler forward and hold in position.
3. Put bit straight into coupler.
4. Move the coupler rear slowly and release.
3.5

REMOVE THE BIT

Figure 4.
1. Pull back the clamp collar and remove the bit.
3.6

FIT AND CHANGE THE SDS BIT

This machine is equipped with an SDS Plus connection
system.
1. Clean the bit and grease it with machine grease before
inserting it into the chuck.
2. Pull back the clamp collar and hold it.
3. Push and turn the dust-free tool into the bit holder as far
as it can go.
4. Release the clamp collar to lock the bit.
5. Examine that bit has locked by pulling on it.
3.7 ASSEMBLE THE AUXILIARY
HANDLE
Figure 5.
1. Turn the handle counterclockwise to loosen the handle
assembly.
2. Move the auxiliary handle onto the hammer drill in one of
two necessary positions, right or left handle.
4
WARNING