Problems And Solutions - Imetec TITANOX H3902 Instrucciones De Uso

PROBLEMS AND SOLUTIONS

This chapter describes the most common problems related to appliance use. If the problems
cannot be resolved with the information below, please contact the Authorised Assistance
Centre.
Problem
The plate (9)
remains cold or
does not heat up.
The plate
temperature LED
Only a little steam
or none at all is
dispensed.
The impurities that
come out from the
steam holes stain
the garments.
Water leaks from
the plate (9).
MI001087.indd 8
Possible cause
There is no power supply.
Normal procedure.
The steam selector (5) is
set to Ø.
There is not enough water
in the reservoir (10).
Chemical additives,
scented liquids or
descaling agents are being
used.
Pure distilled water or
softened water is being
used.
Starch is being used.
The plate temperature
is too cold due to the
Super-steam button being
pressed too often (4).
The temperature
adjustment knob (2) is set
to a temperature that is too
low (Fig. D).
Solution
Verify whether the plug (11) is inserted
correctly or try inserting it in another
socket.
Verify whether the temperature
adjustment knob (2) is set to the
minimum temperature Ø (Fig. D).
This indicates the heating phase of the
iron.
temperature is reached.
Set the steam selector (5) to the
Fill the reservoir (10).
These damage the product: do not add
additives to the water in the reservoir.
Mix tap water (50%) with distilled and/
or demineralised (50%) water.
Always spray the starch on the reverse
side of the fabric.
Allow slightly longer intervals between
the jets of steam.
Turn the temperature adjustment knob
(2) to the Max level (Fig. D).
GB
17
26/01/13 12.23