Samsung RF26 Serie Manual Del Usuario página 9

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of
the appliance. By completing the following steps, your Refriger ator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual.
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly chilled
and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store
food and drinks in the Refrigerator after the temperature is sufficiently cool.
5. Assembly the water line to the refrigerator and verify that the couples are correctly assembled without
water leakage.
Check the accessory list below
Water filter
(DA29-00003B)
COMPONENTS FOR HANDLE ASSEMBLY
[ 3-DOOR TYPE ]
HOW TO ASSEMBLE THE HANDLE
Fridge door handle assembly
. See Controlling the Temperature Section (Page 23).
Hex wrench Fastener
(DA60-00143B)
(DA80-00002C)
OK OK
By using L-wrench, Fix the screw with the Longer part of it and
then fully tighten up with the Shorter part.
To best conceal the connection
points : Assemble the handles
with the mounting screws facing
each other.
Compressin fitting Compression nut
(DA62-00305A) (DA74-00070B)
Fridge
Freezer
the screw and then put the handle
(Optional)
Setting Up _9