Declaration Of Conformity - Beta 3065/20-10T Instrucciones

Ocultar thumbs

Contenido

página de 49

/ 49
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

INSTRUCTIONS FOR USE

ISTRUZIONI PER L'USO

ASSEMBLY

Take the handle, the jack and the extensions out of the cardboard box.

The handle is made of three parts. Before use, assemble as per drawing, using the dowel and wrench

supplied with the jack.

Connect the jack to the compressed air system through the quick coupling on top of the manual lifting/

lowering control of the jack.

Lubrication

The air hydraulic jack must be connected to a filter-lubricator unit with an air-oil microfog mixer (we

recommend Beta item 1919F1/4), set at two drops per minute. This will result in a high-performing tool

and wear-resistant mechanical parts.

If lubrication is not provided to the line, to lubricate the compressed air circuit use the following oils:

• AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100; SHELL TELLUS 100; BP ENERGOL HP 100.

HOW TO USE AIR HYDRAULIC JACK

Lift vehicles as follows:

• Position the jack under the supports as described in the manual of the vehicle manufacturer.

• Use the extensions supplied with the jack together with the relevant plate, if need be (pict.12)

• Pressing A on the control block will enable the lifting mode. (pict.12)

• Pressing B on the control block will enable the lowering mode. (pict.12) With no load, as the pistons

will not go down completely, they must be lowered by hand.

• After lifting the vehicle, before carrying out any jobs under it, place it on suitable stands.

Before lowering the load, check that the handle is in the horizontal position.

Do not stand under the load before placing it on suitable stands.

Before starting lifting operations, secure the vehicle with the emergency brake and/or place

two wedges at the wheels.

• After the jack has been used or if it is not used for prolonged periods, the pistons should be completely

down, and the jack should be stored in a safe, suitable place.

Accessories

The jack is supplied with two extensions or height adapters (60 mm) and a circular tooth plate (16 mm).

DISPOSAL

The jack must be disposed of in compliance with the laws in force in the country where it is used.

WARRANTY

This equipment is manufactured and tested in accordance with current EU regulations, and is covered by

a 12-month warranty for professional use and a 24-month warranty for non professional use respectively.

We will repair any breakdowns caused by material or manufacturing defects by fixing or replacing the

defective pieces or replacing them at our discretion. Should assistance be required once or several times

during the warranty period, the expiry date of this warranty will remain unchanged. This warranty will not cover

defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will no

longer be valid if any changes are made, or if the jack is forced or sent to the customer service in pieces. This

warranty explicitly excludes any damage to people and/or things, whether direct or consequential.