Tabla de contenido
Idiomas disponibles
Idiomas disponibles
the bolt counterclockwise in the center of the abrasive wheel with
the 8 mm hex wrench found in the holder in the base. Bolt has right
hand thread.
3. Remove the bolt, washer, outside flange, and old wheel (Fig. 10).
4. Install the new abrasive wheel by reversing the above steps.
5. Do not over tighten bolt.
DO NOT MAKE ANY ADJUSTMENT WHILE THE WHEEL IS IN MOTION.
DO NOT MAKE ANY ADJUSTMENT WHILE CHOP SAW IS PLUGGED
INTO POWER SUPPLY.
WARNING: CHECK THE WORK SURFACE THAT THE CHOP
SAW RESTS ON WHEN REPLACING WITH A NEW ABRASIVE
WHEEL. IT IS POSSIBLE THAT THE WHEEL MAY CONTACT ANY
ITEMS OR STRUCTURE THAT EXTENDS ABOVE WORK SURFACE
(UNDER THE BASE) WHEN THE ARM IS FULLY LOWERED.
FIG. 11
10-1/8"
(257 MM)
17-3/8"
(441 MM)
FIG. 12
NAIL
Mounting
PROCEDURE FOR PERMANENT MOUNTING
1. Drill four holes 5/16" through the work surface (Figure 11).
2. Insert 1/4-20 screws down through the holes in the base and
through holes in mounting surface. The approximant length of the
screws should be the thickness of the mounting surface plus 4".
CRADLE MOUNTING
1. Cut two boards approximately 20" long x 2" high x 4" wide (508mm
x 50mm x 100mm).
2. Place chop saw at desired work location.
3. Place boards tightly along side, and nail to work surface,
(Figure 12).
FIG. 13
SPRING
END CAP
SCREWS
FIG. 14
BRUSH
6
BRUSH
.3"
(8 MM)
Tabla de contenido
