Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Turn chop saw off before removing any pieces from the base.
• DO NOT CUT ELECTRICALLY LIVE MATERIAL.
• NEVER USE A CIRCULAR SAW BLADE IN THIS CHOP SAW. DO
NOT USE TOOTHED BLADES.
• DO NOT OPERATE THIS TOOL NEAR FLAMMABLE LIQUIDS,
GASES OR DUST. Sparks from cutting or motor may ignite dust
and fumes.
SAVE THESE INSTRUCTIONS
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some exam-
ples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equip-
ment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, saw-
ing, grinding, drilling, and other construction activities. Wear
protective clothing and wash exposed areas with soap and
water. Allowing dust to get into your mouth, eyes, or lay on the skin
may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropri-
ate for the dust exposure. Direct particles away from face and body.
Power Supply
Be sure your power supply agrees with the nameplate marking. 120
volts, "60 Hz" means alternating current (normal 120 volt, 60 Hz house
current). A voltage decrease of more than 10% will cause a loss of
power and overheating.
Cutting Capacity
The wide vise opening and high pivot point provide cutting capacity for
many large pieces. Use the cutting capacity chart to determine total
maximum size of cuts that can be made with a new wheel.
CAUTION: CERTAIN LARGE, CIRCULAR OR IRREGULARLY
SHAPED OBJECTS MAY REQUIRE ADDITIONAL HOLDING
MEANS IF THEY CANNOT BE HELD SECURELY IN VISE.
CAUTION: DO NOT CUT MAGNESIUM WITH THIS TOOL.
Maximum Cutting Capacity
NOTE: CAPACITY SHOWN ON CHART ASSUMES NO WHEEL WEAR
AND OPTIMUM FENCE POSITION.
Standard Equipment
1 14" (355mm) Metal Cutting Abrasive Wheel. Use only high strength
Type 1 organic bonded wheels rated 4,100 rpm or higher.
(Aluminum Oxide)
1 Wheel Wrench
To Carry
Fold down unit to position where you can carry the saw. Push in lock
pin (Figure 1) to lock arm down.
3
Tabla de contenido
