Ratio MR1500NM Manual De Instrucciones página 34

6. DRILLING FUNCTION (See Fig. E1, E2)
1. Adjust the hammer or chisel action selector to
position " " .(See Fig. E1)
2. Adjust the hammer and drilling action selector
to position " " .(See Fig. E2)
3. You are now set up for drilling function.
NOTE: Press the selector switch lock button
before adjusting the dial selector everytime.
E1
7. CHISEL FUNCTION (See Fig. F1, F2)
1. Adjust the hammer and chisel action selector
to position " " .(See Fig. F1)
2. Adjust the hammer and drilling action selector
to position " " .(See Fig.F2)
3. You are now set up for chisel work using chisel
action.
Note: Press the selector switch lock button
before adjusting the dial selector everytime.
WARNING: You must make sure that the
selector switch is positively locked in chisel
mode position. If not, it could cause a hazard.
34
D2
E2
F1
8. DUST COVER (See Fig. G)
Before drilling, fit the dust cover over the drill bit.
CAUTION: Always wear eye protection with
this tool.
G
9. LUBRICATION MACHINE (See Fig.H)
The machine is grease-lubricated. A grease (not
supplied) refill is only required during hammer
work efficiency is low. Open the grease box
lid at the top of the hammer using the spanner
provided. Then refill approx 30g grease(not
supplied). The grease specification is general
purpose lithium based.
CAUTION: Keep the container of grease
away from children.
H
F2