Seko PoolDose pH Manual De Instrucciones página 7

PoolDose | pH · ORP
Save and exit Program setup – Press
Pressing the key determines the exit from the programming menu with saving of the parameters, if the
parameter of the menu item in which one is in has not been changed when pressing the
Set Point adjustment
Press the button for 3 seconds, use
Stand-by mode (backlight on)
Press and buttons simultaneously for 5 seconds to switch off the unit backlight. Dosage and
calibration are disabled. To exit standby, press
Priming
Only while the pump is in stand-by press down
Flowrate counter reset
To reset value of "Partial Totalizer" press
OFA reset
Press the esc button for one click, reset countdown value.
Offset/Slope Menu
Press and buttons the unit show Offset/Slope calibration value, press
menu.
Note: Timeout setting menu, after 120 seconds without action the controller escape itself without saving parameters.
Display example:
pH measure
Alarm list
-
Circ. Pump OFF
-
LEV
-
WDG
-
OFA1 & OFA2
-
Stand By
-
Flow
-
NO WiFi
ORP measure
Alarm list
-
Circ. Pump OFF
-
LEV
-
WDG
-
OFA1 & OFA2
-
Stand By
-
Flow
-
NO WiFi
0000138981
and
and
and
button for 3 seconds, in stand-by mode only.
7.2pH
LEV
720 mV
LEV
rev. 1.0
to set the desired value.
buttons simultaneously.
in the same time.
32°C
Ta 2546m 3
32°C
Ta 2546m 3
EN
key.
or to scroll the
Temperature measure
Flow water totalizer
Absolut
Resettable
Temperature measure
Flow water totalizer
Absolut
Resettable
5