Dimmer Function - Technoline WS6830 Manual De Instrucciones

Press and hold ALM 2 button and at the same time press HOUR button once at a time to set hour or
press MINUTE button once at a time to set minute.
To turn on or off the alarm
To turn on Alarm 1 only, press AL ON/OFF button. The ALM 1 LED lights up on the display.
To turn on Alarm 2 only, press AL ON/OFF button again. The ALM 2 LED lights up on the display.
To turn on both alarms, press AL ON/OFF button again. The ALM 1 and ALM 2 LEDs lights up on
the display.
To in-activate both alarms permanently, press AL ON/OFF button again. The ALM 1 and ALM 2
LED s turn off.
Note: Alarm duration is 5 minutes.
To use the snooze function
When time reaches the set alarm time, the station will give a beep sound to wake you up. The ALM 1
or ALM 2 LED will flash.
1. Press SNOOZE once to stop the alarm temporarily, ALM 1 or ALM 2 LED keeps flashing. The
alarm will beep again after the set snooze duration.
2. To stop the daily alarm, press the ALM 1or ALM 2 button when alarm is beeping. The alarm will
stop and ALM 1or ALM 2 LED becomes static. The alarm will beep again same time next day.
To set snooze duration (from 5 to 60 min)
Press and hold SNOOZE and time display will show 05 (default snooze duration) and then press
MINUTE button to set your desired snooze duration.

DIMMER FUNCTION

Press the SNOOZE / DIMMER button to adjust high or low brightness of the LED display.
TROUBLE SHOOTING
In case the station shows false digits, it maybe affected by electrostatic discharge or interferences
from other devices. Press the RESET button of the station and then takeout and reinstall batteries
into outdoor sensor. The station will be reset to default setting of time and calendar and it will start to
receive radio controlled time signal again.
If you lose the outdoor temperature
When the outdoor temperature digits show "--", the wireless transmission is either interrupted or lost.
Press and hold the MINUTE button of the station, then takeout and reinstall batteries into outdoor
sensor. If you continue to lose the outdoor temperature display, try placing the transmitter in a
different location until you have smooth transmission of temperature data.
Note: Keep in mind that the outdoor transmitter only has a 30 meter transmission range in open area
with no obstructions. Each obstruction between the transmitter and the station (roof, walls, floors,
ceilings, thick trees, etc.) will effectively cut the transmission range in half.
SPECIFICATIONS
Operation temperature:
Temperature measuring range:
Indoor:
Outdoor:
Temperature resolution:
0°C to + 45°C
0°C to +45°C
(display shows HH.H / LL.L if out of this range)
-40°C to +70°C
(display shows HH.H / LL.L if out of this range)
1°C
EN5