BGS technic 3200 Guia Del Usuario página 6

STRUCTURE
No.
1 Spring mounted attachment
2 Bit tray
3 Bit stop
4 Adjustment screw
5 Control screw
6 Feed slide
7 Feed slide lock screw
8 Wing nut
MOUNTING
1. Firmly mount the grinding machine, e.g. on a workbench. In doing so,
make sure that sufficient space is available at the side of the grinding
machine for the installation of the drill grinding attachment. In addition,
the grinding disc protective cover disc must be adjusted to enable the
free area of the grinding disc to be opposite the drill grinding
attachment. The drill bit should be sharpened by an area of the grinding
disc that is on the left of the drive hub of the machine and which is
preferably at the same level or slightly lower than the drive hub of the
grinding machine
2. Position the drill grinding attachment in front of the grinding disc and
parallel to the grinding disc. Mount the drill grinding attachment with a
wing nut (8) onto the workbench (distance to the grinding disc approx. 6
cm). If necessary, insert a spacer (wood) in order to obtain the correct
height to the grinding disc.
3. To determine the correct distance from the grinding disc, if necessary,
insert a drill bit and fit the attachment exactly in front of the grinding
disc.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Designation
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
No. Designation
9 Slotted base
10 Horizontal swivel bearing
11 Swing axis
12 Thumbscrew
13 Bit lip stop
14 Bit tray tip
15 Grinding disc
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed