Kohler K-702100 Manual Del Usuario página 6

Mark holes.
Level
Drill holes.
Wall
Jamb
2. Install the Wall Jambs
IMPORTANT! Always install the bumpers. Bumpers prevent contact between the door panel and frame.
Contact between the frame and door panel can result in breakage.
IMPORTANT! The wall jamb must sit flat against the wall with the legs of the jamb fully engaged with
the bottom track. The wider edge is located toward the outside of the shower.
Locate one of the wall jambs on a shower sidewall. Center the wall jamb on the threshold.
Use a pencil to mark the location of the bottom mounting screw.
NOTE: On ceramic tile, use a center punch to nick the surface glaze at the mark. Tap the punch lightly
with your hammer so you don't crack the tile.
Remove the wall jamb, lightly center punch the hole location, and drill the screw hole using a 5/16"
drill bit. Use a masonry bit for ceramic tile.
Press and hold the leg of the anchor (provided) together and insert the anchor legs into the
pre-drilled mounting hole.
Insert an anchor in the drilled hole.
Loosely secure the wall jamb to the wall with a #8-18 x 1-1/2" panhead screw.
Use a level to plumb the wall jamb.
Use a pencil to mark the remaining two hole locations.
Slide the wall jamb aside and lightly center punch the hole locations.
Drill each hole with a 5/16" drill bit. Use a masonry bit for ceramic tile.
Press and hold the legs of each anchor (provided) together and insert the anchor legs into the
pre-drilled mounting holes.
1036566-2-F
Press and hold legs together.
Insert anchors.
6
Bumper
#8-18 x 1-1/2"
Panhead Screw
Kohler Co.