Safety Instructions - miniland baby nasal care Manual De Instrucciones

1 INTRODUCTION
Congratulations on the purchase of this ergonomic battery operated nasal
aspirator. It will help you make them more comfortable; quickly and gently remove
excess mucus.
Before using this device, please do read carefully all instructions in this manual.
Please keep this manual as it contains important information.
2 CONTENTS
1 Main Unit electronic nasal aspirator
2 Sizes of Silicone Tips
1 Cleaning Tubes
2 Spare Silicone Rings
1 Instruction Manual and guarantee card

3 SAFETY INSTRUCTIONS

1. This device is not a toy; do not allow children to play with it.
2. This device is to clean stuffy noses; do not use it in baby's mouth or ears.
3. Always clean and dry thoroughly before each use and after each use.
4. This is not a waterproof device, please clean it referring to the section of
"Clean Instructions ".
5. Do not insert the silicone tip into the nostril too deep.
6. Do not use it on the baby for a long time. A few seconds will be enough.
7. Do not use this device if there is any wound, or symptom of inflammation
or bleeding at the nose.
8. In the case of infection, fever, nasal irritation or hemorrhage, please stop
using this device and consult your physician.
9. This device is restricted for personal use.
10. The silicone tip is the applied part.
11. No modification of this device is allowed. You are advised that changes
and modifications not carried out on the equipment by the MINILAND
technical service will not be covered by the product guarantee.
12. Duty cycle : 30 seconds ON / 2 minutes OFF
13. Replace batteries when the suction power becomes weak during use.
Battery Warnings:
Use alkaline batteries only
1. Do not mix used and new batteries.
2. Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel-cadmium)
batteries.
3. Only batteries of the same or equivalent type as recommended should be used.
4. Batteries should be inserted with correct polarity.
5. Exhausted batteries should be removed from the device.
6. Be sure that all contact surfaces are clean before installing batteries.
ENGLISH