Charging Battery Pack (Jetvac Accu); Display Battery Charger (Jetvac Accu); Inserting Battery Pack (Jetvac Accu); Beginning/End Of Cleaning - Vermop 7450 Serie Manual Del Usuario

Charging battery pack (Jetvac accu)

The battery pack which is supplied with the Jetvac accu is not fully charged.
Charge the battery pack for at least four hours to ensure that you can use the full capacity.
The charging process begins as soon as the battery pack is attached to the charger.
The average charging time for a fully-discharged battery with 45-minute operation time is ca. 2.5 hours, with
90- minute operation time 5 hours.
[02] Lay the appliance (2) upside down and open the flap on the underside
by turning the runners by 90°. Now remove the battery pack.
[03] Attach the plug of the charger with the power socket. Now insert the battery pack (14)
into the battery charger (13) and switch on the charger (10).

Display battery charger (Jetvac accu)

Red
Yellow
Green/yellow blinking
Green
Red blinking
The electronics recognise a battery short circuit. When a completely discharged battery
(voltage under 21 volt) is inserted, the battery will be charged slowly until the battery voltage
exceeds 21 volts, then a change-over to normal charge takes place.
As soon as the battery pack has been completely charged, switch off the charger and pull out
the mains plug. Now remove the battery pack.

Inserting battery pack (Jetvac accu)

[04] Insert the battery pack (14) into the appliance, until the yellow locks click into place.
Close the flap and secure it by turning the guides to the starting position.
Tip:
When using the Jetvac accu you can read the state of charge
from the display when the appliance is on.

Beginning/end of cleaning

[06] Before beginning vacuuming, flip the mains switch to Level "1".
Jetvac: Pressing the grey foot switch once will switch the machine on (1, 2) and activate vacuum
setting 1; pressing the grey foot switch again (x2) activates vacuum setting 2 (highest setting); pressing
the grey foot switch again after this (x3) switches the machine off (1, 2).
When vacuuming has been completed, the mains switch should be switched to level "0" and the mains
cable unplugged from the socket.
20
172378_ANL_Jetvac-Jetvac_Accu_A5_RZ_VERSION_2019.indd 20
Battery completely discharged or no battery attached
Battery is being normally charged
Battery is almost fully charged
Battery is fully charged
Battery defective
04.04.2019 11:42:00