Operation Procedure - HURAKAN HKN-GP1000 Manual Del Usuario

EN
• Do not move the machine while it is operating.
• The machine is not intended for use by children, persons with physical, mental or intellectual
disabilities, as well as individuals without experience and relevant knowledge. An exception may
be given to the individuals supervised or briefed by the person responsible for their safety.
Attention! Stop using the machine if it operates incorrectly, if it is damaged or dropped, or if the
power cord or plug is damaged.
BLOWER ASSEMBLY INSTRUCTIONS
Install the blower on the base of the hot air pipe, adjust the direction by rotating it, align the
oval hole of the blower with the screw hole on the hot air pipe, and tighten the screws.
INSTRUCTIONS FOR ASSEMBLING BRUSHES
Install the brush rod on the base of the drive shaft, turn it counterclockwise so that the
perpendicular pin on the drive shaft fits into the recess on the brush handle. (Tip: the short
brush should be put on the center rod).

OPERATION PROCEDURE

Step 1.
Connect the glass polishing machine to the
mains.
18