HURAKAN HKN-GP1000 Manual Del Usuario página 17

EN
3. Assemble the brushes and make sure they are securely attached. The brushes are made of
microfiber; during operation, the hot air from the blower keeps the brushes dry for effective
polishing; wet brushes cannot dry and polish glasses. Brushes should always be dry. If the
brushes fail to dry in a high load, take a break for 20 minutes and leave the machine on to allow
the brushes to dry.
Attention! Connect the machine only to an earthed socket with frequency and voltage matching
the frequency and voltage specified for the motor!
Do not allow the switch to come into contact with water, keep it dry!
Before turning on the machine, make sure that the brushes are securely attached!
Do not use the machine for purposes other than intended!
SAFETY
Attention! Only the individuals familiar with this manual and briefed on safety may be allowed
to use this equipment.
• Make sure that the glass froster does not come into contact with flammable materials during
operation, such as curtains, upholstery materials, walls, etc., and is not covered by them.
• Please note that the use of accessories not recommended by the manufacturer may cause
injury.
• When using the machine in stores, bars, hotels, etc., check the voltage and the socket and
make sure it is properly connected to the power mains.
• During installation, setting up, operation, maintenance, and repair, in addition to observing
the safety requirements set forth in this manual, occupational safety, fire safety, and health
standards should be strictly observed in accordance with the regulations of the country where
this machine is operated.
• Keep the machine out of the reach of children.
• Do not store flammable items in the immediate vicinity of the machine.
• If the machine is not used, it should be disconnected from the mains.
• If the machine is not in use or is used in adverse weather conditions, disconnect it from the
power supply to prevent accidents.
• It is strictly forbidden to wash the device with an open source of water. Failure to observe this
rule may result in equipment damage and personal injury, possibly fatal. Do not allow water to
come in contact with the socket and switch.
• Wash the machine surfaces only after they have cooled down.
• Before washing, repairing, or moving the machine, disconnect it from the power supply.
• Do not touch the power cable with wet hands to avoid the risk of electric shock.
• Clean non-working surfaces of the machine with a soft, dry cloth.
• Carry out maintenance or repair work only after the machine has been disconnected from the
power supply.
• Do not touch the switch or plug with wet hands.
• Do not forcefully pull the power cord so as not to damage it and cause electrical leakage.
17