Tabla de contenido
Idiomas disponibles
Idiomas disponibles
POWER ON/OFF AND VOLUME
Press the MENU/
button for at least three seconds to
turn the radio on/off. During power on, the radio will
beep two times with different tones, the LCD will display
several icons for one second and then the LCD display
will indicate the last channel selected.
To increase/decrease the volume level, press the ▲\▼
buttons during RX or standby mode.
RESTORING YOUR RADIO TO THE
ORIGINAL SETTING
To reset your radio to the original (default) setting, turn
on the radio while pressing and holding the ▲ button.
The LCD display will reset to standby mode on channel 1
with no privacy code.
TRANSMITTING AND RECEIVING A CALL
To communicate, all radios in your group must be set to
the same channel and/or privacy code.
1.
For maximum clarity, hold the radio at least 1" from
your mouth.
2. Press and hold the PTT button and speak in a normal
voice into the microphone. The TX icon will appear
continuously on the LCD display while transmitting.
3. To receive a call, release the PTT button. The RX
icon will appear on the display when your radio is
receiving a transmission.
ABOUT RANGE
Your radios are designed to give you maximum range
under optimum conditions. (See Figure 3)
Figure 3
Maximum Range / Little to no sight obstruction
Medium Range / Partial obstruction to line of sight
Short Range / Major obstruction to line of sight
PAGE 4 OF 21
OPERATION
OPTIMUM CONDITIONS ARE:
• Over water
• Open rural areas without obstructions
• Flat areas where you can see the other person
TO ENSURE MAXIMUM RANGE:
• Be sure to use fresh or fully charged batteries – low
batteries will cause low power conditions.
• Be sure you are on a GMRS channel – FRS channels
are restricted by the FCC to low power.
• Be sure to set your radio to use Hi power.
T50 SERIES QUICK REFERENCE CHART
MENU
Channel
1-22
MONITOR
Pressing and holding the MON/SCAN button for three
seconds will let you hear noise so you can adjust the
volume level of the radio when not receiving a signal. This
could also be used to check any activity on your current
channel before transmitting. Press and hold the MON/SCAN
button for three seconds again to get out of monitor mode.
SCAN
Your radio can scan all 22 channels for activity. To enter,
quickly press the MON/SCAN button. Repeat the same
procedure to exit. Your radio will rapidly scan each of
the 22 channels and stop on any active channel for six
seconds before resuming scan. When you press the PTT
button to transmit on an active channel, the scanning
function will stop and remain on the active channel. To
resume scanning, quickly press the MON/SCAN button.
CALL ALERT
Your radio can transmit a call alert. To send a call alert,
press the
/CALL button. The TX icon will appear while
transmitting a call alert and a tone can be heard on
the speaker for confirmation.
VOX
CTCSS
oF/1/2/3
oF-38
WX Channel
Press and hold
UP/WX button
for 5 seconds
1-10
Roger Beep
Silent Operation
On/Off
On/Off
WX Alert
On/Off
0521 IH-6112
Tabla de contenido
