Using The Cd Player - Teac TASCAM CD-VT1 Manual Del Propietário

Using the CD player

 e s  player works  e s  player works
in much the same way as other  in much the same way as other 
players with a few minor diff erences players with a few minor diff erences
and special features as explained on and special features as explained on
this page
oad s label side up shiny side
down in the  pen and
close the player door by hand by lifting
the door tab marked PULL
 e display shows when the door
OPEN
is opened when it is closed and
CLOSE
when a s able of on
TOC READ
tents  is being scanned by the
unit after being loaded
NOTE
The CD-VT1 cannot play unfi nalized CD-R/
RW discs. In addition, some fi nalized CD-R/
RW discs may be unplayable on the CD-VT1.
Playback
ress the playpause 
Á/π
start playback and to pause playback
ress the stop key   to stop play
ª
back
10
— TASCAM CD-VT1
Display
se the
DISPLAY/ESC
the display between track elapsed
time track remaining time and total
remaining time you cannot do this in
menu mode
Skipping between tracks
se the two skipsearch keys marked

as
Ô?Â
back and forward a track at a time by
pressing and releasing the appropriate
key
Searching within tracks
se the skipsearch keys to search
within the disc by pressing and hold
ing the appropriate key
The CUE key
 e CUE key is a special feature of the
 hen you press this key the
 key to
playback position returns to the last
point where playback started
hat happens next depends on the
menu item setting in the
CUE
key to change
and  to move
¯?,
MENU
menuf this is set to
CUE
paused at the cue point but if it is set
to  playback restarts from the cue
FLS
point  is shown on the display
FLASH
Looping (track)
sing the menu item set
PLAY
gle play ress the LOOP
you see on the display bottom
LOOP 1
left  e current track will repeat
Looping (disc)
sing the menu item set
PLAY
all the disc ress the LOOP
that you see alone on the display
LOOP
bottom left  e whole disc will
repeat
Looping (I/O points)
se the I/O key to set the start in
point of the loop then use the key to
set the end out point  e section be
tween the points will repeat seamlessly
ressing the key again clears the
I/O
loop points and cancels loop mode
 playback is
sin
SGL
key so that
play
ALL
key so