GE AEE18 Manual Del Propietário página 11

PREPARE THE CASE (continues)
4
Attach the side retainers to the case using 6
E
type A screws. Mount the screws from the
inside of the wall case.
PREPARE THE WINDOW AND INSTALL 5
THE CASE
A
Cut the window sash seal to the length of the
window sash. Peel off the backing and attach the
seal to the underside of the window sash.
B Open the window and mark the center of
the window sill.
Carefully slide the case into the window
C
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window sill. Mount the case
to the window sill using 2 type C screws.
Drill pilot holes, if necessary.
Sill
Installation Instructions
2 type C screws
PREPARE THE WINDOW AND INSTALL
5
THE CASE (continues)
Assemble the V-support and Sill Angle
D
bracket with Type F nut and bolt
Left
Sill angle
bracket
V-support Type
F bolt and nut
Position the left
E
V-support under the left
side panel of the wall
case and against the
outside wall. Adjust the
Sill Angle Bracket to
rest on the sill. Attach
the V-support to the wall case using 2 Type
E bolts. Re-adjust the Sill Angle Bracket if
necessary.
Repeat with Right V-Support.
F
Extend the left and right accordion panels
G
to the vertical window sashes. Drill pilot
holes and attach the top corners with 2 type
C screws.
Type C
screw
11
Type E bolt
and nut
Right
V-support
Sill
V-support
Type C
screw