Product Specifications; Care And Maintenance - Homewerks EL-4224 Manual De Instrucciones

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. flow rate: 1.2 GPM (4.542 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Chrome finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Apply clear silicone latex caulk
(2.1) (not included) to the base
plate (2.2) on the bottom of the
faucet.
3. Position the faucet (A) on the sink
surface (3.1).
Hand tighten the mounting nuts
(B) to the faucet (A) tailpieces
(3.2) on the underside of the sink
(3.1).
OPERATION INSTRUCTIONS
Each handle controls the flow of either hot or cold water to
the spout.

CARE AND MAINTENANCE

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and
void your warranty.
1
2
2. 1
2.2
3
A
3. 1
3. 2
B
SPECIFICATIONS
Washerless cartridges
Manufactured to include no more than 0.25% weighted
average lead content on wetted surfaces
4. Connect the Water Supply Lines
If using a flexible braided supply
line (4.1) (not included), connect
the end with 1/2 in. female IPS to
the tailpiece (4.2) of the faucet.
Hand tighten. Do not overtighten.
Install the other end of the supply
line (4.1) to the shut-off valve or
supply tube.
If using a ball-tip supply line (4.3)
(not included), slip a coupling nut
(4.4) (not included) behind the
ball-tip. Insert the ball-tip into the
faucet tailpiece (4.2). Tighten
coupling nut (4.4). Do not
overtighten.
NOTE: Do not use plumbers tape
on connections, this will void the
warranty.
5. Turn water supply or shut-off valve
back on and check for leaks. If leaks
occur, tighten nuts slightly.
6. Remove aerator (6.1) from the
spout. Turn on the faucet (A)
and run the water for at least
30 seconds to flush out the water
lines. Turn off the faucet (A) and
replace aerator (6.1).
To create a moderate water temperature, turn both handles
open. Slight adjustments of either handle will cause the water
temperature to increase or decrease.
2
4
4. 2
4. 4
4. 1 4. 3
5
6
A
6. 1
www.homewerksww.com
4. 2