SIT Group 630 EUROSIT Manual Del Usuario página 6

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WARNING:
Fire or Explosion Hazard.
Can cause property damage, severe injury or death.
Follow these instructions completely.
1. Turn off gas supply at the appliance service valve before installation, and perform a Gas
Leak Test after the installation is completed.
2. Always install the sediment trap in the gas supply line to prevent contamination of the gas
control.
3. Do not force the control knob. Use only your hand to turn the knob. If the knob does not
move by hand, the valve should be replaced by a trained service technician.
WARNING:
Oxygen Depletion Hazard.
Can cause injury or death by asphyxiation.
Do not use valves for vented appliances on unvented or vent free appliances. Do not use
valves for unvented or vent free appliances on vented appliances.
CAUTION
Electrical shock or equipment damage hazard.
Can shock individuals or short equipment circuitry.
Make sure to disconnect all electrical supplies before beginning the installation process.
IMPORTANT
- These gas controls are shipped with anti-contamination seals over inlets and outlets.
- Do not remove the seals until ready for connection to piping.
- Appliance manufacturer's instructions supercede any instructions listed in this instruction book.
INSTALL PIPING TO GAS VALVE
All piping must comply with local codes and ordinances or with the National Fuel Gas code (ANSI
Z223.1 NFPA No. 54) whichever applies. Tubing installation must comply with approved standards
and practices. Use appropriately sized fittings when connecting aluminum tubing to the pilot outlet.
1. Use new, clean and correctly reamed pipe free
from burrs,chips, debris and any foreign matter.
When tubing is used, make sure the ends are
square and clean. All tubing bends must be smooth
and without deformation.
2. Run pipe or tubing to the valve. If tubing is used,
obtain a tube-to-pipe coupling to connect the
tubing to the valve.
3. Install sediment trap (Drip Leg) in the supply line to
6
the gas valve
GAS SUPPLY
TO CONTROL
INLET
3" MIN.
DRIP LEG (DOWN)
Tabla de contenido
loading

Productos relacionados para SIT Group 630 EUROSIT

Tabla de contenido