ADA INSTRUMENTS CUBE 3D GREEN Manual Del Usuario página 4

4
English
1
LASER LINES
2
FEATURES
1. Laser emitting window
2. Battery cover
3. Compensator switch
4. Tripod mount 1/4''
5. Vertical laser window
6. Laser lines on/off and receiver mode
SAFETY REQUIREMENTS AND CARE
Follow safety requirements! Don't face and stare at laser beam!
Laser level is an accurate Instrument, which should be stored and used
with care.
Avoid shaking and vibrations! Store the Instrument and It's accessories
only In the carrying case.
In case of high humidity and low temperature, dry out the Instrument and
clean It after the usage.
Do not store the Instrument at a temperature below -20°C and above 50°C,
otherwise the Instrument can be out of action.
Don't put the Instrument Into the carrying case If the Instrument or case
are wet. To avoid moisture condensation Inside the Instrument- dry out the
case and laser Instrument!
Check regularly Instrument adjustment!
Keep the lens clean and dry. To clean the Instrument use a soft cotton napkin!
OPERATION
Cube 3D GREEN is a reliable and convenient instrument. It will be irreplace-
able instrument for many years.
-Open battery compartment. Insert batteries into the battery compartment.
Observe the polarity. Close the battery compartment. Take out batteries if
you are not going to use the tool for a long time.
-Place the instrument on the working surface or mount it on the tripod/
pillar or wall mount.
Switch on the instrument. Turn the compensator switch (3) to the position
"ON" (the instrument is turned off in the position OFF).
Visual alarm (blinking line) and audible signal indicate that the device was
not installed within the compensation range ±3º. To properly work align the