Modes Of Use - La Sommeliere ECELLAR185 Manual De Instrucciones

•
Warning! To prevent the wine cellar from tipping over, it is important to load the rear positions
first. The shelves must not be pulled out or left out at the same time. The weight of the bottles
can cause the cellar to tilt forwards, it is essential to distribute the weight of the bottles
throughout the cellar and to handle it with care.
•
Warning! Do not pull out the 14 connected shelves at the same time once loaded.
•
Warning! If bottles are placed on a shelf, perform the operation delicately so as not to
damage the central support.
•
Warning! The shelves are not made to accommodate bottles with a diameter greater than 9
cm.
•
Warning! In the event of a bottle breakage, it is important to remove the bottles and clean the
holes in the central bar of the shelves where the sensors are placed, using a soft, dry cloth.
Be sure to rescan your bottles before placing them back in your cellar.
•
Warning! During the first use, the user must remove the protective plastic film placed on the
front of each shelf.
The shelves have indicator lights (LED) which indicate to the user:
•
Desired bottle(s)
•
Recommended location (refer to the paragraph on the E-Sommelier function)
•
Detection of bottles by the cellar when removing or adding bottles
Warning: in a particular case, the front led lights may remain on, they will turn off automatically after 5
minutes.

Modes of use

Your cellar has two temperature modes:
•
The "mono-temperature" mode is activated by default. It allows the
choice of a single temperature throughout the cellar between +5
and + 20 ° C.In this mode the fans are activated to ensure the
circulation of air in the cellar. The temperature displayed on the
digital screen corresponds to the set temperature and the message
"MONO" is displayed.
•
The "multi-temperature" mode makes it possible to obtain different
temperatures inside the cellar, in the form of a gradient ranging from
a warmer temperature at the top of the cellar, temperate in the
middle and colder at the bottom of the cellar. In this mode the fans
are disabled. The setpoint temperature is fixed automatically and
cannot be changed, the screen displays "AUTO"; the device
automatically manages the temperature. No adjustment is
necessary.
Here are the temperatures that can be reached in multi-temperature mode
under normal conditions of use, i.e. an ambient temperature of 25 ° C maximum (refer to the section
"Installing your wine cabinet"). The temperature distribution indicated in the table is given as an
indication, as variations may occur between the different levels depending on the cooling cycles, the
number of bottles loaded in the cellar and the outside ambient temperature. The air flows inside the
cavity will be influenced by these different factors.
57