Assembly; Mounting The Transport Wheels (02) - AL-KO Easy Crush MH 2810 Manual Del Usuario

GB
Personal protective equipment:
■
Wear clothing and protective equipment in
accordance with the regulations in order to
avoid injuries to the eyes, as well as to avoid
hearing impairment.
■
The clothing must be appropriate (tightly fit-
ting) and must not restrict movements. If you
have long hair, it is essential to wear a hair
net. The personal protective equipment com-
prises:
■
Ear protection
■
Protective glasses
■
Work gloves
■
Safety shoes
■
Long trousers
Working area:
■
No further persons, children or animals may
be in the working area of the shredder.
■
Keep the working area free from material to
be shredded and other objects – danger of
stumbling.
■
The user of the machine is responsible for
accidents involving other persons or their
property.
■
Ensure good lighting of the working area.
Operating times:
■
When operating in residential areas, observe
country-specific and communally permitted
operating times according to the regulations
on noise pollution.
■
Work with the machine in daylight or with
good lighting only.
Operation:
■
Do not reach into the hopper or feed chute
during operation!
■
The cutting disk (MH 2810) or cutting drum
(LH 2810) runs on after the machine has
been switched off!
■
Only put the machine into operation when as-
sembly has been completed.
■
Always perform a visible inspection prior to
using the machine. The machine must be in a
safe operating condition.
■
Never work alone.
■
Immediately renew damaged or worn parts.
■
Only use the machine if it is in the technical
condition stipulated by the manufacturer.
■
Do not undertake shredding work in the rain,
snow, stormy weather or during thunder-
22
storms (danger of lightning!). Do not use the
shredder in wet or damp surroundings.
■
Do not deactivate safety and/or protective de-
vices on the machine.
■
Always ensure that the machine is stable be-
fore starting work.
■
Never transport the shredder with the motor
running.
■
Never transport the shredder with open or
unlocked shredder upper section.
■
Before moving the shredder, switch off the
motor, wait for the cutting disk (MH 2810) or
cutting drum (LH 2810) to come to a standstill
and disconnect the machine from the mains
power supply.
■
When moving the shredder, transport it only
with its handle (01/1).
■
Always ensure a stable stance when working.
Do not bend forward too far.
■
Do not feed the shredder from an elevated
position.
■
Always disconnect the shredder from the
mains power supply when not in use.
In the event of a malfunction or accident:
■
Immediately disconnect the mains plug from
the mains if the mains cable has been dam-
aged or severed!
■
If a foreign object is drawn in or in the event
of unusual noises or vibrations, immediately
switch off the shredder and disconnect it from
the mains. Then proceed as follows:
■
Inspect the damage.
■
Refasten loose parts, e.g. tighten screws.
■
Have all damaged parts exchanged or re-
paired by our customer service.

5 ASSEMBLY

CAUTION! Danger of injury if the ma-
chine is incomplete! Incomplete machines can
lead to injuries and damage to the machine!
■
Do not operate the machine until it has been
fully assembled.
5.1

Mounting the transport wheels (02)

1. Slide the wheel shaft (02/1) into the base
(02/2).
2. Next, slide a large 10x20x1.5 washer (02/3)
and the bushing (02/4) onto the shaft (02/1).
3. Afterwards, slide the transport wheel (02/5)
onto the bushing (02/4).
Assembly