marklin mLD3 Manual De Instrucciones página 7

CV Explanation
260 Bit 0: Motor buffering off/on
Bit 1: Sound buffering off/on
Bit 3: SUSI bus buffering off/on
263 Bit 0: Front light(s) buffering off/on
Bit 1: Rear light(s) buffering off/on
Bit 2: Aux 1 buffering off/on
Bit 3: Aux 2 buffering off/on
Bit 4: Aux 3 buffering off/on
Bit 5: Aux 4 buffering off/on
270 Buffering Distance (cm)
271 Stopping Distance (cm)
272 Adjusting motor energy
280 Buffering Time Aux (s)
281 Buffering Time for Sound (s)
282 Buffering Time for SUSI Bus (s)
943 Dependence on the charge level of the
1
buffer off/on
944 Charging threshold (V)
The buffer is charged above this voltage.
945 Discharge threshold (V)
The buffer supplies power to the users
below this voltage.
1
only in digital operation
2
only in analog operation
Values
0/1
0/2
0/8
0/1
0/2
0/4
0/8
0/16
0/32
0-255 (20)
0-255 (25)
0-255 (0)
0-255
0-255
0-255
0/1 (0)
2
0-255 (100) 1
2
0-255 (80)
Notes
The values of the required settings must be added up.
The values of the required settings must be added up.
The value is the same as the buffering distance in cm.
The value is the same as the stopping distance in cm.
If the buffered locomotive is too slow, the value must be increased.
0 = endless
1 = 0.05 seconds
20 = 1 second
Value to be entered = desired time in seconds (s) / 0.05 seconds
0 = Locomotive starts running independently of the charge level of the buffer
1 = Locomotive only starts running when the voltage buffer is fully charged
= 0.1 volts
100 = 10 volts
Value to be entered = desired voltage in volts (V) / 0.1 volts
1 = 0.1 volts
100 = 10 volts
Value to be entered = desired voltage in volts (V) / 0.1 volts
7