DVO GARNET Guía De Configuración Del Manual Del Propietario página 11

10. Once you have measured out 11mm's of
gap, place the locking nut on the cable.
Use a 3mm wrench and a 2mm wrench to
tighten the lock nut.
Trim any excess cable.
11. Place the locking nut into the release arm
on the bottom of the post. Insert the lock-
ing nut first, then rotate the cable down-
ward so it fits within the groove.
12. Once the cable is securely placed into the
release arm, pull on the cable from the
remote end to lower the post into the
frame.
Torque the seat clamp device to the frame
manufacturer's lowest specification. Do
not exceed 5 -7 Nm as this will prevent the
seatpost from functioning properly.
GARNET DROPPER OWNER'S MANUAL & SET UP GUIDE
ENGLISH
3
2
11