Sharp AN-SV100T Manual Del Usuario página 16

Attaching the Ceiling Mount to the Ceiling (Continued)
When installed with the AN-TK202
Attach the ceiling mount to the ceiling.
• First screw a bolt into the hole
Then, do the same for the holes
Position the four corners correctly, and then tighten all bolts fi rmly.
• Use M8-type bolts. (Bolt type may vary depending on the method of installation.)
• Use the washers supplied with the ceiling mount.
Caution
• Ask your dealer or service shop to install the ceiling mount. Sharp will assume no responsibility
whatsoever if inadequate installation causes your projector or attached devices to fall out of
place.
For the customer's safety, reinforce the
point of installation so that it is strong
enough to bear the weight of the whole
system before installing it.
Info
• Only qualifi ed servicemen should install the
projector. Never let the customer install the
system by him/herself.
14
(smallest hole) and tighten it enough to keep the mount in place.
, and .
To the dealer or serviceman