Operation And Mode Of Working - Meister i-drill pico 2.0 MAS 36ip2 Traducción De Las Instrucciones De Servicio Originales

MC-5450490-Bedien-0910_b 24.09.10 08:52 Seite 70
8 – Operation and mode of
working
Placing the tools (Fig. 3)
Insert the bit adapter (b) into the bit
holder (4) as far as it will go. Select a
suitable bit (a) and insert it into the bit
adapter.
Screwdriver and drill bits with a length
upwards of 50 mm can also be inserted
directly into the bit holder.
Select direction of rotation,
clockwise/counterclockwise
Inserting screws: Set switch for
clock wise or counterclockwise
rotation (2) to "Clockwise" as
shown in Fig. 1.
Loosening screws: Set switch for
clock wise or counterclockwise
rotation (2) to "Counterclockwise"
as shown in Fig. 1.
The LED charging and rotational
direction (5) shows, during operation,
and according to the position of the
right/left switch (2), the rotational
direction that has been selected by
means of the green light on the relevant
arrow display: Right = ▲, Left = ▼
A brief display of a red light from the
charging display when activating the
on/off switch (1) shows that the
charge is almost exhausted and the
battery must be recharged.
70
Prior to start up
Fit a suitable bit or socket to the battery-
powered screwdriver and place firmly
against the screw.
Starting and stopping
Caution! Risk of over winding
caused by screwing screws in too
deep. Watch the screwing process
carefully and, if necessary, stop early
and finish the process with an ordinary
screwdriver. Always practise first!
• Starting:
Press the ON/OFF switch (1): The
screwing process will start. Press and
keep the switch during the screwing
process.
• Stopping:
As soon as the screw has been screwed
in or removed fully, release the On/Off
switch. The process is completed and
the working light will go out.
Switching on the LED working light
When the unit is switched on,
LED
the LED working light (3) also
comes on to ensure better vision
and to make working in dark areas more
safe. The working light goes out when
the On/Off switch is released..
CAUTION! LED is laser class 1!
Do not look directly into the
laser as this may result in damage to
the eyes.