Purpose Of Use; Work Area Safety - Beta 1838SLIM Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
OPERATING MANUAL AND INSTRUCTIONS FOR RECHARGEABLE, ARTICULATED,
ULTRASLIM 3-LED INSPECTION LAMP:
BETA UTENSILI S.P.A.
VIA A. VOLTA 18,
20845, SOVICO (MB) ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE LAMP. FAILURE TO COMPLY WITH THE SAFETY STANDARDS
AND OPERATING PROCEDURES MAY RESULT IN
SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

The lamp can be used for the following purpose:
• lighting workplaces.
The lamp must not be used for the following operations:
• must not come into contact with chemical and corrosive substances
• must not be used for any applications other than recommended ones

WORK AREA SAFETY

Do not operate the lamp in environments containing potentially explosive atmospheres, because
sparks may be generated, which can ignite the dust or fumes.
LED LAMP SAFETY
• Before use, check that the lamp has not been damaged, and that no parts are worn.
• Do not force the electronic circuit of the lamp. Do not modify the lamp. This can reduce the effective-
ness of safety measures and increase operator risk.
• The LED light source cannot be replaced; if it is either damaged or at the end of its life cycle, replace
the entire lamp.
• To clean the lamp, use a dry cloth and always disconnect the mains power supply from the lamp.
PERSONNEL SAFETY INSTRUCTIONS
• Stay alert; watch what you are doing.
• Do not direct the LED light beam at people or animals: this may cause temporary blinding.
• Keep the lamp out of the reach of children.
BATTERY USE AND CARE
•
• Check that the power supply cable is in good condition.
• Fully charge the lamp when not using it for a long time.
• Do not charge the lamp in humid or wet environments; do not expose it to the weather.
EN I
5