Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING YOUR TEA KETTLE
INITIAL USE
Before first use, run the kettle through several cleaning cycles following the
instructions below to remove factory material or dust from the interior. Discard the
water from these cleaning cycles.
CAUTION: The lled water level must be between the Max and Min level
as indicated on the housing. Too little water will do damage to the heat
element. Water over ll may cause boiling water to over ow out of the kettle.
OPERATION
1. Raise Lid by pressing down on Latch
Button in top of Lid (Fig. 2). Pour water
Fig. 2
into kettle to desired level and close Lid.
Ensure that Lid Latch on kettle interior is
not obstructed and that Lid completely
closes.
2. Place kettle on Power Base (Fig. 3).
Position kettle so that spout faces away
from you.
3. Plug kettle into a power outlet. The
Control Panel Display will light up green
for a few seconds to indicate electrical
connection and then dim to gray until
the next press of a button. The Display
defaults to the Heat Water icon [
]
and 212°F (Fig. 4). Pressing the Function
Button [ ] will display the Keep Warm
icon [
] and default temperature of
190°F (Fig. 5). Another press displays
the Boil Extend icon [ ] and default
time of 3 seconds (Fig. 6). Press the
Power button to immediately begin
heating to those default levels.
4. To adjust the Heat Water, Keep Warm
Fig. 4
Fig. 4
and Boil Extend settings, press the Down
or Up buttons when the function is
selected in the display. Boil Extend
adjustment is only available for 212°F
Heat Water.
Down
Note: Heat Water and Keep Warm adjust
in 10ºF increments to a minimum of 110ºF.
Function
Boil Extend adjusts in 1 second increments
to a maximum of 6 seconds.
4
OPERATING YOUR TEA KETTLE
OPERATION cont.
5. When the settings are as desired, press
the Power button to start heating. The
Heat Water icon will start blinking,
indicating that heating is underway.
Once water reaches the temperature
setting, the blinking Keep Warm icon
will appear in the display, indicating the
temperature at which the water will be
kept. If the Heat Water setting is 212°F,
the display will pass to the blinking Boil
Extend icon before it passes to the Keep
Warm icon.
Note: The Boil Extend function is for
operation at high altitude locations, where
water can begin to boil before it reaches
the normal boiling temperature of 212°F.
The extra 3 to 6 seconds that can be
added to heating are so that water may
heat to 212°F before the unit switches to
Keep Warm.
6. When it is raised from the Power Base the kettle shuts off and all setting adjustments
Fig. 3
are canceled. The kettle reverts to the default settings once it is placed back onto
the Power Base.
CAUTION: Be very careful when pouring water from kettle as boiling water can scald
you. Also to avoid scalding, do not open the kettle lid while the water in the kettle is hot.
EMPTY-STOP-OFF FUNCTION
The kettle will turn off automatically if it boils empty. If this occurs, unplug the
kettle and wait for it to cool down before using it again.
Up
Power
Fig. 5
Fig. 5
Fig. 4
Down
Up
Function
Power
Fig. 6
Fig. 6
Down
Up
Function
Power
5
Tabla de contenido
