STEP 3
Pre-drill holes using your
3/16" drill bit. See the table
below for measurements
specific to your filler height.
After pre-drilling has been
completed on one cabinet
side, repeat with adjacent
cabinet.
Mount filler cabinet pullout to
adjacent cabinets. Make sure
filler is flush with the top of
the cabinet wall and behind
the face-frame if applicable.
Mount filler cabinet pullout to
remaining adjacent cabinet.
3
16
#2
STEP 4
Remove front shipping strap.
(See Fig 4)
Attach onlays or door panels.
(not provided). (See Fig 5)
NOTE
Metal brackets cannot be
pre-drilled or screwed into.
#2
FIG.
3
Filler Size (Height)
26" Filler
30" Filler
FIG.
4
Shipping Strap
INSTALLATION INSTRUCTIONS: BLUM 432 VANITY SC FILLER
Measurement #1
From Top of Cabinet, Down
From Top of Cabinet, Down
3/8"
3/8"
Install onlay using slots for side to
side adjustment
Use micro adjustment screw for door
tilt adjustment
Screw 432 to cabinet top from above
adjacent cabinet
From inside and above the adjacent
cabinet foor, screw the 432 to cabinet
bottom
Measurement #2
23-7/8"
27-7/8"
FIG.
5
3
