Technical Specifications; Remote Control - STEINEL PROFESSIONAL IR Quattro KNX Manual De Instrucciones

Technical Specifications

KNX mains connection:
Settings:
Lighting channels:
Light 1 – Light 4
Stay-'ON' time:
Light measurement:
Basic brightness :
Stay-'ON' time:
HVAC output:
Switch-on delay:
Stay-'ON' time:
Presence stay-'ON' time output: 1 – 255 sec.
Further outputs:
Square detection zones:
Presence:
Radially:
Tangentially:
Angle of coverage:
Reach:

Remote Control

Using the PC 7 user remote
control (optional), functions can
be conveniently activated from
the floor.
24 V via KNX bus voltage
by means of ETS software, remote control or bus
Switching/dimming;
switching mode - constant-lighting control
IQ mode, 1 – 30 min.,
depending on presence and light level
Mixed light
OFF/ 10% – 50%
Basic brightness 'ON' duration, 1 – 30 min.
depending on presence
Room surveillance, 1 – 30 min.
1 – 120 min.
Light level, scenario-controlled
IR Quattro KNX
no more than 4 x 4 m (16 sqm)
no more than 5 x 5 m (25 sqm)
no more than 7 x 7 m (49 sqm)
HF 360 KNX
360° with 140° aperture angle
also through glass, wood and
stud walls. 1 or 2
detection directions can be
masked out for adjustment to
the room situation.
HF 360 KNX
at most 8 m all-round,
at least 1/3, 2/3,
max. electronically
selectable setting
(ETS software, KNX bus,
remote control RC 6)
Service remote control
RC 6 (optional) permits
convenient configuration
(see Accessories on p. 15)
- 18 -
IR Quattro HD KNX
no more than 8 x 8 m (64 sqm)
no more than 8 x 8 m (64 sqm)
no more than 20 x 20 m (400
sqm)
DUAL HF KNX
refer to diagram on p. 17
also through glass, wood
and stud walls.
DUAL HF KNX
min., 1/3, 2/3, max.
electronically selectable
setting in either direction
(ETS software, KNX bus,
remote control RC 6)