1- Safety in formation
ing safety hints!This appliance is intended to be used exclusively for
the storage of wine.
WARNING!
Make sure there is no transport damage.
Remove all packaging and keep out of children's reach.
If your wine cellar has been tilted for any reason, wait 24 hours be-
fore plugging it in.
Handle the appliance always with at least two persons because it
is heavy.
Handle the appliance always with at least two persons because it
is heavy.
Wait at least two hours before installing the appliance in order to
Installation
The appliance should be placed in a well-ventilated place. Ensure
a space of at least 10 cm around the appliance. It is designed for
free-standing installation only, not for built-in installation.
Never place the appliance in a damp area or location where it
might be splashed with water. Clean and dry water splashes and
stains with a soft clean cloth.
Do not install your wine cellar in any location not properly insulat-
lated or heated e.g. garage etc. Your wine cellar was not designed
to operate in ambient temperature below 16 °C.
Do not install the appliance in direct sunlight or near heat sources
(e.g. stoves, heaters).
Install and level the appliance in an area suitable for its size and use.
Keep ventilation openings in the appliance or in the in-built struc-
ture clear of obstruction.
Make sure that the electrical information on the rating plate agrees
with the power supply. If it does not, contact an electrician.
The appliance is operated by a 220-240 VAC/50 Hz power sup -
to start, or damage the temperature control or compressor, or
an abnormal noise when operating. In such a case, an automatic
regulator shall be mounted.
Use a separate, easily-accessible, earthed socket for the power
supply. The appliance must be earthed.
Only for UK:
pliance is installed, the plug should be accessible.
Do not use multi-plug adapters and extension cables.
4
GB
-
-