Uline H-3129 Manual Del Usuario

H-3129
5/8" HIGH PERFORMANCE
GLUE GUN
TOOL INCLUDED
Screwdriver (Built Into Base)
Temperature Control
Nozzle
Trigger
On/Off Switch
NOTE: The glue gun should be unplugged
after each use. The adhesive can be stored
indefinitely in the unheated gun and re-melted
by heating up the tool.
1. Use built-in screwdriver to adjust temperature control.
NOTE: The glue gun comes pre-set at 375°F.
1. Keep out of reach of children.
2. Never touch the gun's nozzle or the melted glue.
Operating temperatures reach 450°F and can cause
severe burns. Immediately immerse any accidental
burns in cold water and seek medical attention.
3. Do not use within 10 feet of flammable materials.
4. Not for outdoor use or in areas that may be wet or
damp.
5. Keep all work areas clean and well lit.
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
2. Plug the glue gun into a 120 volt AC outlet; when red
light illuminates on/off switch, the power is on.
Glue Feed
3. Insert 5/8" glue stick into glue feed. Allow the glue
gun to heat for approximately 3 to 5 minutes.
Stroke Adjuster
4. When the gun is fully heated, squeeze trigger slowly.
The melted glue will begin to flow from nozzle.
Release the trigger to stop the glue flow.
Power Input
5. The output volume of the glue can be adjusted by
turning the stroke adjuster clockwise.
6. If glue drips excessively, replace the nozzle. To
change, heat the gun for a minute until glue is
softened enough to remove the nozzle. While
wearing gloves, use a wrench to remove the old
nozzle. Flush glue through the gun and attach the
new nozzle.
SAFETY
6. Never use with materials other than recommended
glue sticks.
7. Always wear protective safety equipment such as gloves,
glasses, and long sleeve shirts and pants when using.
8. When inserting glue sticks in glue gun, avoid using too
much force.
9. If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent to avoid a hazard.
10. Always follow basic safety precautions when operating.
Pour le français, consulter la page 3.
CAUTION! Once glue gun heats up, the nozzle
and melted glue are extremely hot. Avoid
touching.
NOTE: Use short nozzle for general use or long
nozzle for harder to reach areas.
Para Español, vea página 2.
0421 IH-3129