Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Table Saw MPBTS254L User Manual
1.Secure the fence to the correct measuring position and remove the cut-off guide from the bench
carriage.
2.Turn the saw blade approximately 2 mm higher than the total thickness of the wood to be sawn.
3.Press the wood lightly towards the bench and let it glide against the cut-off fence.
Remain at least 3 cm. from the front of the saw blade before you switch on the engine. The side of the
wood which is against the fence must be completely straight. Keep your hands at least 10 cm away from
the saw track to be followed.
1.Switch on the engine and wait until the saw blade has reached the maximum number of revolutions
before you start sawing.
2.While you press the wood against the bench and the fence, you can carefully push the wood through the
saw blade without forcing it.
3.Never pull the workpiece backwards. If necessary, switch off the engine first without altering the position
of the workpiece.
Lengthwise sawing with a(vertical) mitre
This method is practically the same, except that the saw blade is placed at the angle required.
With this type of method the fence may only be along the righthand side of the sawblade.
Lengthwise sawing of narrow workpieces.
Assume that this process is extremely dangerous.
Take all the necessary safety measures and continually push the workpiece through (until behind the saw
blade) using a synthetic aid instead of by hand.
Crosswise sawing
1.Remove the fence and apply the cross-cut fence in the righthand carriage.
2.Adjust the height of the saw blade (see lengthwise sawing).
3.Press the workpiece against the cross-cut fence and keep at least 2,5 cm distance from the front of the
saw blade.
4.Switch on the engine and wait until the maximum number of revolutions has been reached.
5.Press the workpiece against the fence and the bench. Carefully push the wood through the saw blade.
Continue until behind the saw blade. Then switch off the engine and keep this position until the saw blade
has stopped completely before you remove the wood.
6.Never pull the wood back. If necessary, switch the engine off and keep the position until the saw blade
has stopped completely.
Crosswise sawing with a vertical mitre
This method is practically the same, except that the saw blade is placed in the angle required.
Only place the cross-cut fence on the righthand side of the saw blade.Never saw too small pieces of
wood. Never use your hands to carry out difficult operations.
Crosswise sawing with a horizontal mitr
With this method the cross-cut fence must be secured at the angle required. Keep the workpiece pressed
firmly against the cross-cut fence and the bench before you start cutting off.
CLEANING AND MAINTENENCE
Attention !Before performing any work on the equipment, pull the power plug.
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may damage the plastic
parts.
Lubrication
The machine requires no additional lubrication.
STORAGE
GB
12
Tabla de contenido
