Basic Features; Setting The Clock; Setting The Alarm - Philips AJ3010/04 Manual De Instrucciones

XP AJ3010/00 20-06-2000 16:33

BASIC FEATURES

ILLUMINATION BRIGHTNESS
Press REPEAT ALARM/
BRIGHTNESS CONTROL
™ The brightness of the display will change in this sequence:
BRIGHT DIM
Note:
When an alarm or the SLEEP function is active, brightness
cannot be adjusted.

SETTING THE CLOCK

The time is displayed using the 24 hour clock.
1. Press TIME SET for more than 2 seconds to enter time
setting mode.
™ Time displays and flash.
2. Press HR or MIN repeatedly or hold down on the button to
adjust the hours and minutes respectively. Release HR or
MIN when you reach the correct setting.
3. After you have set both the hours and minutes,
press TIME SET to confirm the correct setting.
™ Clock time also starts to run automatically after
60 seconds after you adjust the time.
Note:
Press ALARM SET during time setting will switch to alarm
setting mode.
6
Pagina 6
once or more.
BRIGHT...
RADIO
1. Press SLEEP / RADIO ON once to switch on the radio.
2. Select your waveband using the BAND switch.
3. Use TUNING to find your radio station.
4. Adjust the sound using VOLUME.
5. Press ALARM RESET / RADIO OFF to switch off.
To improve reception:
FM: extend and position the pigtail aerial to obtain optimum
reception.
MW (or LW): uses a built-in antenna inside the set. Direct
the antenna by adjusting the position of your set.

SETTING THE ALARM

General
If you wish to use the alarm, first set the alarm time.
There is a choice of two alarm modes, buzzer or radio. The
alarm display shows the alarm time all the time and the alarm
indicator appears if the alarm is set.