Traxon LIGHT-DRIVE JOG RGB Manual De Usuario página 6

USING THE LIGHT-DRIVE JOG DW
Color Temperature
Save/Recall 1
Jog Wheel
Switch ON Unit: Press the Jog Wheel once to switch on. Press Jog Wheel again to switch off.
Tune Color Temperature: Press Color Temperature button once and turn Jog Wheel to tune
the color temperature.
Tune Brightness: Press Brightness button once and turn Jog Wheel to tune the brightness.
Press and hold Brightness button for 2 seconds or more for maximum brightness.
Save/Recall 1 & 2: Press Save/Recall (m1 or m2) button once to recall a saved setting. To
save a setting, after tuning the color temperature and brightness, press and hold the
Save/Recall button (m1 or m2) for at least 4 seconds. A beep sound is emitted to confirm the
setting is saved.
Idle Mode: The unit enters Idle Mode when no button is pressed after 20 seconds. In idle
mode, LED fixtures remain on; the backlight on the jog wheel is on. Press the Jog Wheel once
to exit idle mode. Idle mode can be disabled by simultaneously holding down the Color
Temperature and Brightness buttons for 5 seconds.
Standby Mode: The unit enters Standby Mode when the Jog Wheel is tapped gently.
Connected LED fixtures will fade off. In standby mode, the backlight of the jog wheel is on.
Disable or Enable the Buzzer: With the Light-Drive Jog switched on, press and hold the Jog
Wheel for 4 seconds until you hear a short beep.
5
Brightness
Save/Recall 2