Traxon LIGHT-DRIVE JOG RGB Manual De Usuario página 4

USING THE LIGHT-DRIVE JOG RGB
Color
Speed
Jog Wheel
Switch ON Unit: Press the Jog Wheel once to switch on. Press Jog Wheel again to switch off.
Tune Color: Press Color button once and turn Jog Wheel to tune the color.
Tune Brightness: Press Brightness button once and turn Jog Wheel to tune the brightness.
Press and hold Brightness button for 2 seconds or more for maximum brightness.
Rainbow Color Sequence: Press the Play/Pause button once to activate rainbow color rolling
sequence. Press the Play/Pause button again to pause color rolling. Press the Speed button
once and turn the Jog Wheel to change the color rolling speed. Ten complete turns of the Jog
Wheel adjusts the speed of the rolling cycle between 0.5 seconds and 20 minutes.
Idle Mode: The unit enters Idle Mode when no button is pressed after 20 seconds. In idle
mode, LED fixtures remain on; the backlight on the jog wheel is on. Press the Jog Wheel once
to exit idle mode. Idle mode can be disabled by simultaneously holding down the Color and
Brightness buttons for 5 seconds.
Standby Mode: The unit enters Standby Mode when the Jog Wheel is tapped gently.
Connected LED fixtures will fade off. In Standby Mode, the backlight of the jog wheel is on.
Disable or Enable the Buzzer: With the Light-Drive Jog switched on, press and hold the Jog
Wheel for 4 seconds until you hear a short beep.
3
Brightness
Play/Pause