Maintain The Prism Iii Printer; Clean The Print Head; Clean The Prism Iii Print Head Using A Prism Cleaning Kit - Rimage Prism III Guia Del Usuario

Maintain the Prism III Printer

Clean the Print Head

Clean the print head at every ribbon change, or more often if streaks start to
appear or the ribbon has torn.
There are two methods for cleaning the Prism III print head—the Prism
cleaning kit method, and the alternate method. The alternate method
can be used when a cleaning kit is not available. This section provides
instructions for both methods.
Note: If the Prism printer is connected to an autoloader or AutoPrinter, it
may be easier to remove the printer from the system before you begin the
cleaning process.
• Power off the printer.
• Remove all cables and cords from the back of the printer. Refer to the
Identify the Parts of the Prism Printer
• Remove the printer from the system and place it on a flat surface near a
power outlet.
• Connect a separate power cord from the back of the printer to a power
outlet.

Clean the Prism III Print Head Using a Prism Cleaning Kit

If you have a Prism cleaning kit, use the following procedure to clean the
print head.
# Required tools:
Prism cleaning kit (PN 210555-001)
•
One disc
•
99% Isopropyl alcohol
•
Cotton swabs
•
1. Prepare the Prism for cleaning.
a. Power off the Prism.
b. Remove the top cover.
c. Remove the ribbon. Refer to the
page 18.
2001809_A
section on page 6.
Change the Print Ribbon
section on
For more information visit
2. Begin cleaning mode.
a. While pressing and holding the operator button, press the power
switch to power on the Prism.
b. When the Disc Not Present indicator light (the second light on the
operator panel) flashes, release the operator button. The printer
tray opens.
The printer is in cleaning mode when the operator button and Disc
Not Present indicator lights (the top two indicator lights on the
control panel) blink rapidly.
3. Prepare the cleaning pad.
Note: The cleaning pad is included in the Prism cleaning kit.
a. Remove the adhesive backing from the cleaning pad.
b. Attach the cleaning pad to the top of a disc.
c. Make sure that the edges of the pad are aligned with the disc.
d. Place the cleaning pad with the attached disc on the printer tray.
Make sure the disc is aligned with the retaining pins on the printer
tray.
e. Press the pad down and over the sensor on the printer tray.
f. Place 5 drops of isopropyl alcohol on the cleaning pad.
rimage.com/support
Pad Pressed Down Over
Sensor
Cleaning Pad with Attached
Disc
Printer Tray
16