Maintenance; Problem Solutions - Skymsen SFL-282HD Manual De Instrucciones

SFL-315HD 220 V 60 Hz

6. MAINTENANCE

Maintenance must be considered a set of procedures
with the purpose to keep the equipment best opera ng
condi ons, therefore increasing the equipment life and
safety.
Cleaning – check item 5 CLEANING
Wiring - Check all wires regarding deteriorate condi ons as
well as all electric contacts (terminals) regarding ghtening
and corrosion .
Contacts – ON/OFF switch, emergency bu on, reset bu on,
electronic circuits, etc., check the equipment in order to
assure that all components are correctly working and the
equipment opera on is normal .
Installa on – make sure the installa on followed item 3
instruc ons.
Life span: 50.000 cycles as per test standard.
1 – Each month check:
- Check the electrical installa on
- Measure the voltage at the socket
- Measure the working current and match it with the
nominal current
- Check the ghtening of all electric terminals to avoid bad
contacts
- Check electric motor sha clearance

7. PROBLEM SOLUTIONS

PROBLEMS
- Lack of Power;
- The equipment does not
- Problem with the internal or
switch on.
external electric circuits.
- Machine switch on but when - Belt slipping on pulleys.
product touches the blade it
stops or runs slowly. - Damaged Motor.
- Problem with the internal or
- Smoke or burn smell.
external electric circuits. - Dirty Blade or Wheel.
- Blade breaks frequently.
- Wheel Damaged.
- Damaged Cord. - Problem during transporta on.
- Unusual noises. - Problemas com rolamentos.
- Dirty blade or wheels.
- Blade with wrong tension;
- Difficul es to cut the product.
- Blade is not on wheels center;
- Blunt blade.
- Check the wiring for overea ng , insula on failures and
mechanical damages.
2 Each three month checks
- Check electrical components such as ON/OFF switch,
emergency bu on , reset bu on, electronic electric circuits ,
overea ng, insula on failings, or mechanical damages
- Check bearings clearances
- Check retainers, O'rings, V'rings and other seals
Use Your QR Code Reader to access
more informa on regarding safety and
maintenance.
CAUSES SOLUTIONS
- Check if there is electric power.
- Call Technical Assistance.
- Adjust the blade tension, see item 4.2.3;
- Call Technical Assistance.
- Call Technical Assistance.
- Clean,see the item 5 CLEANING.
- Call Technical Assistance.
- Call Technical Assistance.
- Call Technical Assistance.
- Clean, see the item 5 CLEANING;
- Adjust the blade tension, see item 4.2.3;
- Call Technical Assistance.
- Change the Blade.