For Future Reference - Brentwood Appliances MPI-41 Instrucciones De Operación Y Seguridad

• Do not put any stress on the power cord where it connects to the product, as the power
cord could fray and break.
SPECIAL INSTRUCTIONS:
• The Iron should always be turned to "MIN" before plugging or unplugging from outlet.
• Always disconnect Iron from electrical outlet when filling with water, emptying or when
not in use.
• Burns can occur from touching hot metal parts, hot water or hot steam. Use caution when
you turn the Steam Iron upside down as there still be hot water in the reservoir.
• Never immerse the iron, cable or plug in any liquid.
• A short power supply cord is provided to reduce the risk of becoming entangled in or
tripping over a longer cord. An extension cord is not recommended for use with this
product, but if one must be used:
 The marked electrical rating must be at least as great as that of the product;
 If the product is of a 3-prong grounding type, the extension cord must be a grounding-
type 3-wire cord.
 Arrange the extension cord so that it will not drape over the countertop or tabletop
where it can be tripped over or pulled.
WARNING: This product is equipped with a polarized plug (one blade is
wider than the other blade) to reduce the risk of electrical shock. This is a
safety feature. The plug will fit into a polarized outlet only one way. If you
are unable to insert the plug into the electrical outlet, try reversing the plug. If the plug still
does not fit, contact a qualified electrician. Never use the plug with an extension cord unless
you can fully insert the plug into the extension cord. Do not alter the plug. Do not attempt to
defeat the safety purpose of the polarized plug.
Before First Use
IMPORTANT: Please check all packaging material carefully before discarding as there may be accessory
parts contained within the packaging material.
Attention: First use may cause a slight odor or small smoking upon heating, it is normal. This is a result of
the heating element chemical reaction.
1. Insert the power plug into a correctly installed and earthed mains power socket.
2. Hold the steam brush horizontally.
3. Place the temperature regulator at the position "．．．",at the same time please turn off the
adjustable horizontal steam regulator. Just like this.
4. Heat the steam brush up at the highest setting for a few minutes. By doing this you will clear
production residues from the sole of the appliance.
5. Then iron a redundant piece of material, this will remove any impurities that may possibly be on the
sole of the iron
SAVE THESE INSTRUCTIONS

FOR FUTURE REFERENCE

3