About Hdd And Ssd; About M.2 Ssd Slot; How To Connect The Internet; Wireless Lan - Monster Tulpar T7 Manual Del Usuario

EN
• Drag and Drop
You can move files or objects in your notebook by using drag-and-drop. To do so,
place the cursor on the desired item and slightly tap twice on the touchpad, and then
keep your fingertip in contact with the touchpad on the second tap. Now, you can
drag the selected item to the desired location by moving your finger on the touchpad,
and then lift your finger from the touchpad to drop the item into place. Alternately,
you can press and hold the left button when you select an item, and then move your
finger to the desired location; finally, release the left button to finish the drag-anddrop
operation.

About HDD and SSD

This notebook may be equipped with hard disk drive (HDD) or solid state drive (SSD)
depending on the models users purchased.
The hard disk drive and solid state drive are the data storage devices used for storing and
retrieving digital information. Most SSDs use NAND-based flash memory, and have higher
data transfer rates, lower power consumption, and faster read/write speed than HDDs.
Do not attempt to remove or install the HDD and SSD when the notebook is powered on.
Please consult an authorized retailer or service center for the replacement of the HDDs
and SSDs.

About M.2 SSD Slot

The notebook may be equipped with M.2 SSD slots for M.2 SSD cards, which are
compatible with SATA or PCIe interfaces, providing diverse features and usages to users.
Consult an authorized retailer or service center for correct specifications and installations.

How to Connect the Internet

• Wireless LAN

Wireless LAN is a wireless broadband connection that allows you to connect to the Internet
without using any cables. Follow the instructions as below to set up a Wireless LAN
connection.
1. Open up Settings, find and click [Network & Internet].
2. Select [Wi-Fi] within the Network & Internet selection menu.
3. Switch [ON] the Wi-Fi function if it is set to [Off].
4. Select [Show available networks] to open up the network selection table.
5. Make sure [Airplane mode] is turn off.
6. Select [Wi-Fi] here.
7. Choose one Wireless LAN connection from the network list to connect to the
Internet. Click [Connect] to continue.
8. A security key may be required for connecting the selected network. Then click [Next].
31