Pentair PENTEK PPC7 Serie Manual De Instalación página 8

Operation
1
step 1: Push 'MODE' one time. Display will show P
(for 'Parameter') and a number (identifies the parameter).
2
step 2: Turn the knob. The number on the display will
change. Continue to turn the knob until the number for
the parameter you wish to set is displayed.
NOTE: The numbers will be in sequence, but will not
be consecutive (that is, some numbers are skipped).
3
step 3: Once the number of the parameter you wish to
set is displayed, push 'SET' to display the current value of
that parameter.
4
step 4: Turn the knob until the desired setting is
displayed.
NOTE: The speed at which you turn the knob determines
the rate at which the setting changes. For instance,
turning the knob slowly might change the setting by
decimals, while turning the knob rapidly might change
the setting by tens. This speeds up the setting process
while preserving accuracy in the setting.
5
step 5: Once the correct setting is displayed, push
'SET' again to capture the parameter. The display will
alternate between the parameter number being set and
the setting selected.
Push 'MODE' twice to return to the standard display
(Hz, Amps, or PSI). See 'To Return to the Standard
Display', at right.
8