BAUKER D1401A Manual De Instrucciones página 17

METAL scan
Left edge Right edge
Stud center is the center of two dot line
The tool detects increasing proximity to metal objects. The position where you start
is important. To work, the tool must start at some position away from metallic
objects. If to close, an error in indicated.
METAL scan function section The scanning procedure is same as in STUD mode.
REMARK : when doing METAL scanning ,like rebar, scan in both horizontal and
vertical directions. Metal sensitivity increases when metal object is parallel to sensor.
35
Center of stud is the middel between
the two marks.
Choose the "MODE" button to set the tool to
ELECTRONIC STUD SENSOR
AC detection
The Multi-Scanner scans for position of "hot" wires. The position where you start is
important. For maximum sensitivity, begin by placing the tool at some position away
from hot wiring. Choose the "MODE" button to set the tool to AC function section
.The scanning procedure is same as in STUD mode.
REMARK : when doing AC scanning, scan in both horizontal and vertical directions.
AC sensitivity increases when AC object is parallel to sensor.
AC wiring presence is detected, the "lighting" symbol will be displayed and pitch
sound will be generated.
Caution:
* Wires deeper than 4cm from surface might not be detected. Always turn off the
power when working near electrical wires.
* Static charge may spread voltage detection as much as 12 in (30 cm) laterally
from actual wire location.
* If you suspect there are wires but find none, they may be shielded in conduit. Use
METAL scan to find metal conduit.
When hot unshielded
36