BAUKER D1401A Manual De Instrucciones página 15

Protecting the environment
If you want to dispose of the tool yourself, the battery must be removed as describe
above and disposed of in accordance with local regulations. Place the battery in a
suitable packing to ensure that the terminals can not be short-circuited. Take the
batteries to a local recycling station.
1. Installation of the battery
1.1 Open battery door at the back of the unit.
1.2 Attach a 9 Volt battery to the connector.
1.3 Put the battery into the compartment.
1.4 Close battery compartment door.
2. Operation instruction:
2.1 Power on
Push the button " " the tool will be powered on.
Push the button " " will turn off the tool.
2.2 Select:
Choose desired detection mode by cycling the various modes with the "MODE"
button. STUD----METAL ----DEEP ----- AC
31
ELECTRONIC STUD SENSOR
3. Calibration device
The device must be calibrated to the characteristics of the body
(wall, floor, ceiling):
- Prior to the start of each search
- regularly during a search process (after every 60 seconds)
Calibration is required again after 60 seconds, in order to reduce the
occurrence of measurement errors.
1. Hold device against the surface (selection location whether the object searched for
is very unlikely to be).
2. Keep calibration press down and do not move the device, the icon
flashing on LCD. When the icon to stop flashing, and 3 short beeping
tones .Confirm successful calibration .
3. Continue to keep key pressed and start search.
Note:
The calibration button must remain pressed during the entire search process
(calibration and search).
If you calibrate too closely to the object or directly on the wood, the calibration can
fail. If the calibration fails, the LCD display shows the following
symbol and a long beeping tone sounds.
Please switch the device on again in order to start the calibration.
Move and hold the device several centimetres further to the right or left of the
previous surface and recalibrate.
32